Modeling of Control Guide in FreeCAD

Hello friends welcome to FreeCAD tutorial in our previous tutorial we have learned Modeling of Slotted Guide in FreeCAD.  In this tutorial we will do modeling of Control Guide with the help of Part design workbench of FreeCAD. You can also download my source file of the tutorial at https://www.mechnexus.com/mechnexus-youtube-tutorial-source-file/ so let’s start our tutorial.

Freecad Ad 01

Also Read-:

FreeCAD Part Modeling Tutorial 33
FreeCAD Part Modeling Tutorial 34
FreeCAD Part Modeling Tutorial 47

Model Control Guide In Freecad

Control Guide 02

Select the front plane and create the below sketch.

01

Now Extrude the sketch to 100mm and keep it symmetric to plane.

02

Now select the right face and create the below sketch.

03

Now Remove the material as shown in Below image.

04

Now select the front face and create the below sketch.

05

Now Remove the material as shown in below image.

06

Now select the face and create the below sketch with shown dimension.

07

Now remove the material as shown in below image.

08

Now select the right face and create the below slot sketch.

09

Remove the material as shown in below image.

10

Now select the all 4 edges and create the fillet as shown in below image.

11

Now select the face and create the below sketch.

12

Now extrude it and set end condition to up to face as shown in below image.

13

Now project the edge and create the circle of 15mm as shown in below image.

14

Now remove the material as shown in below image.

15

Now select the top face and create the below hole sketch.

16

Now create the hole as shown in below image.

17

Now create the fillet as shown in below image.

18

“Thank you for reading! If you found this article insightful and valuable, consider sharing it with your friends and followers on social media. Your share can help others discover this content too. Let’s spread knowledge together. Your support is greatly appreciated!”

Amar Patel
About Amar Patel 182 Articles
Hi, I am Amar Patel from India. Founder, Author and Administrator of mechnexus.com. I am a Simple Average Man who Loves life and Love living life. Professionally I am a Mechanical Engineer with Solid command over CAD software like FreeCAD, SolidWorks, Autodesk Inventor and AutoCAD Mechanical. I’m here to share my knowledge to help you accomplish your design and engineering tasks quicker and easier. I am Passionate about learning new things especially about Open-Source Software. I love teaching therefore I started my YouTube Channel on FreeCAD and I believe FreeCAD have lots of potential than traditional 3D software. contact me - [email protected]